Diameter (In): 2.36 (6 cm)
Depth (In): 0.63
Material: 4 mil PVC plastic.
Pouring temperatures of any product should not exceed 140 degrees F. Pouring above these temperatures may warp or damage the mold and we will NOT replace molds.
Mold size and pouring temperature of soap will determine set up time. It is imperative that you allow soap to cool completely before trying to remove from any mold. Depressions will occur in the top of mold if you try to release soap by force. Allow molded soaps to sit for at least 1 hour for best results. Gently pull the at the sides of the mold. This releases entrapped air between the mold and soap. Using firm, but gentle pressure, push on the top of mold until soap is released. If you are still having difficulty, place mold in the freezer for 10-15 minutes.
No posts found